JDS Drainage

Due to the rerouting of a kitchen waste pipe, it was necessary to reconfigure our customer's internal waste outlet. This was carried out by coring a hole through the wall and redirecting the kitchen waste pipe through and down into the new gully. Once all works were completed, we cleared the site and left in a clean and tidy manner.

Our customer's kitchen waste pipe had come away from the internal stack which contained asbestos so couldn’t be disturbed. We carried out an excavation from underneath the kitchen window to the downstream chamber, installed a new gully complete with a new pipe run and connected into the chamber. Once connected, we concreted in the gully, surrounded the new pipe run in 10mm shingle and backfilled up to existing levels.

Our customer was experiencing issues with a recess cover located on a customers pathway not set square to the chamber and regularly blocking. We carefully removed the slabs and broke out the area down to a suitable depth. We removed the existing frame and reset it, square to the chamber on a bed of soft sand and cement. Once set we surrounded the area in concrete to existing level. Once the concrete base had set, we reinstated the slabs to existing levels making cuts where ne

This job was to carry out an excavation onto a 3m section of pitch fibre pipework that was badly deformed and blistered. We carried out...

A run of approximately 9m of existing pitch fibre pipework needed to be replaced with new 100mm plastic pipe at our customer's property....

This job was to supply and install and new plastic kitchen gully due to existing clay being in poor condition and causing constant...

This job was to dig on the bottom of a soil pipe and remove a gully trap buried underneath the concrete. We disconnected the stack and...

This job was to supply and install approx 45m of new 63mm poly main, due to the existing water main being in very poor condition and kept...

This job was to supply and install a new mdpe 28mm water main. We excavated a trench from the property boundary up to a point of entry up...

A new water main was required at my customer's property. I excavated a 900mm deep trench from the property boundary up to the side of the...

My customer required 4 new gullies to take rainwater from the roof. After installing the 4 gullies and concreting in, I dug a trench to a...

This job was to supply and install a new upvc gully to take away the rainwater from a roof. We cut straight lines with a petrol spinner...

This customer has a treatment plant which pumps the water to a soakaway after treatment. They have had problems with blockages in the...

This was a dangerous sink hole that had formed due to a damaged rainwater pipe . We dug down to the pipework to find that a poor...

My customer's storm water gully was completely blocked with roots and silt. Once cleared by high pressure water jetting, cctv used to...

This job was to stop an area of the patio from flooding when it rained. A previous contractor had installed a gully from a section of...

This foul system was suffering from badly deformed and blistered pitch fibre pipes, a common problem with this type of pipe. I had to...

This property had a rainwater gully going to a soak away which was not draining. I removed the old gully and installed a upvc replacement...

My customer required a new gully to take away the rainwater from a roof. I excavated down to a clay foul pipe, cut a section out and...

This was a cast iron soil stack which had been badly split due to the cold weather. We replaced the cast iron pipework with a new plastic...